 
Monarchy Audio SE-250 Hybrid (Tube/Solid State) Monoblock Power Amplifier $ 5000 / pair
| All handcrafted in California
|
|
SPECIFICATIONS; Absolute Zero Feedback: No global, No local Feedback
Architecture: One Dual Triode used in an SRPP configuration;
12 pcs of complimentary MOSFET in Output Stage.
Tube: One 6DJ8 Military Grade. Can be substituted with 6922 or ECC88.
Customer can specify 6N1P if desired.(The sonic characteristics of
this amp depends to a large extend on the choice of this input tube)
Other dual triodes with the same pin-out and filament voltage
may be substituted to attain personal taste.
The current-output stage is totally transparent, so if there are
any sonic characteristics observable on this amp, it would be
attributable to the tube’s own sonics.
Input Sensitivity: 2.5 Volt RMS for full output.
Output: 250 Watts rms on 8 Ohm load
500 Watts rms on 4 Ohm load
will operate with speakers that dips into 2 Ohm
at part of the frequency spectrum.
AC Input:: 117V or 240V (must be specified when ordering)
Maximum power consumption: 800 Watts.
Input Impedance: 100K Ohms, direct coupled. RCA connection only.
Output Terminals: Gold plated all solid brass thumb screw.
Relay and fuse protected.
Slew Rate: 80V/usec. minimum.
Frequency Response: 20 Hz to 20KHz +/- 0.25 dB at full power.
Construction: All Aluminum chassis with Thermalloy high-efficiency
Heat Dissipating fins.
Power Supply: +/- 60V DC from a 850 Watt toroidal transformer
Exclusive Dual-bridge Low Noise Rectification.
Class of Operation: a) Front end: Single-ended Pure Class A.
b) Output Stage: Class A biased up to 50 Watts,
then Class AB to full output.
Dimension: 12.5” x 5” x 16”
Net weight: 46 Lbs; Gross Weight: 50 Lbs
Color & Finish: Chassis: Black anodized. Front panel: Smoked silver
Lapped (polished) to Hubble-mirror like. 
|
